2018 ford escape hybrid9/11/2023 ![]() Lowering driver’s side window may help to complete this process on larger vehicles.The video shows a Ford Focus, but the same procedure will work on a Ford Escape Troubleshooting tips Turn ignition OFF then start the engine.Press OK on TPMS tool to transfer data to ECU.Repeat for the right front, right rear and left rear sensors.Hold TPMS tester on left front tire sidewall next to the valve stem, use TPMS tool to activate the sensor.Confirm TPMS sensors are properly installed.OBDII module is required, attach to the tool.The video shows a Ford Edge, but the same procedure will work on a Ford Escape OBD relearn procedure, years 2014-2020: Repeat for right front, right rear and left rear tires.A single horn sounds to indicate sensor learning successful.Use the tool to activate the left front sensor.Push START button 6 times (NOTE: 9 times if 2x-to-RUN).Push START button 5 times (NOTE: 8 times if 2x-to-RUN).With the vehicle OFF, push and release the brake pedal.If this is the case, modify steps 3 and 5 as noted. Important note, some models require the start button to be pressed twice (without pressing the brake) to enter RUN mode (Ignition ON/Engine OFF).Manual relearn procedure (push-button start): TRAINING MODE COMPLETE will display on the message center when relearn is finished.A single horn sounds to indicate learning successful.Use your TPMS tool to activate the left front sensor.A single horn chirp will indicate the relearn mode is active.NOTE: All the steps for this process must be performed within 10 seconds.Quickly turn the ignition from OFF to RUN (engine OFF) three times, stop in RUN position.Engage the parking brake and inflate all tires.Manual relearn procedure (standard ignition): TPMS activation tool ( VT56, VT55, VT15, VT31, VT36 and VT46 brands) for a manual (stationary) relearn, step by step relearn procedures are written in the tool for the VT56, VT55 or VT46 brands and are available to complete a TPMS reset in the owners manual for the VT36, VT31 or VT15 tools.TPMS Diagnostic tool ( VT56 or VT46 brands), step by step relearn procedures are written in the tool.Type of TPMS tool required for TPMS reset: ![]() ![]() Bonus OBD relearn procedure coverage as an option on the VT56 for years 2014-2019, requires OBD module.Manual, two types, standard ignition, and push-button start.All OE and aftermarket TPMS part numbers and service kit replacement options for the Ford Focus can be found in the VT56, VT55, VT46 brands and VT36 TPMS Tools in “Service TPMS”. A TPMS relearn is recommended when replacing a sensor.Direct TPMS, TPMS sensors are installed in the wheel, tire pressure is communicated via radio frequency (RF) technology from the sensor to the vehicle’s ECU.When one or more sensors are replaced in a Ford Escape, a TPMS relearn is recommended to write the ID’s to the vehicle’s ECU to turn the TPMS light off. An indicator light (low-line TPMS system) or each tire pressure will show on the dash (high-line TPMS system). If one or more tires indicate low tire pressure, the TPMS sensors will transfer the information to the vehicle’s ECU. The Ford Escape uses a direct TPMS system, which means TPMS sensors are installed in the wheel. After the TREAD Act was mandated in 2007, all vehicles manufactured in the United States beginning in 2008, must be installed with direct or indirect TPMS systems. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |